Power Kite Forum
Not logged in [Login - Register]
Go To Bottom

Printable Version  
Author: Subject: Converting 2 way valve to 1 way valve?
friezadeathball




Posts: 5
Registered: 2-23-2018
Member Is Offline


[*] posted on 10-12-2018 at 11:38 AM
Converting 2 way valve to 1 way valve?


Hello Everyone,

I have an old C-kite with 2 way valves. Is there anyway to convert them to 1 way valves? Anyone have any knowledge in this area? Please do advise. I'll replace the valves if it is an absolute must. Please share your thoughts. Thanks.
View user's profile View All Posts By User
Snake




Posts: 453
Registered: 7-5-2012
Location: Midwest
Member Is Offline

Mood: Boost to the moon

[*] posted on 10-13-2018 at 12:33 AM


I assume by two way you mean air can flow freely in or out of the valve? If so, a little technique can make prevent all the air from flowing out when you pull the pump nozzle out. If you pinch the valve body then pull the nozzle out and are fast about putting the plug in, almost no air should leak out.

What I am concerned about is that you are flying an old C-kite. Those are dangerous kites without much depower and lack safety features of newer kites. Many people have been seriously injured by these old kites. If this kite is anything more than a light wind novelty, I would recommend finding a newer kite as it will be much easier and safer to fly.




Arcs - Charger I 8m, 10m, 12m, Venom I 13m - F-Arc 1200, 1600
Single Skin - Born-Kite LongStar2
Fixed Bridles - Pansh Legend 4.5m - Peter Lynn Voltage 3m
View user's profile View All Posts By User

  Go To Top

Hosted by: Mad Moose Studio