Power Kite Forum
Not logged in [Login - Register]
Go To Bottom

Printable Version  
Author: Subject: Welder/machine shop needed to make buggy
shortlineflyer




Posts: 793
Registered: 4-23-2010
Location: Alexandria, Virginia
Member Is Offline


[*] posted on 7-6-2016 at 09:21 AM
Welder/machine shop needed to make buggy


I have a kite trike and love it but sooner or later it will completely rust out and I like the way it rides. I want to get another one built whenever I can. Is there anyone who would undertake that project. I was thinking either stainless or steel with epoxy coating. The epoxy coating I could do my self with some spray epoxy paint I found at an auto shop. Right now I just want the rails and axle done.

Is there a a way to drill out a 20 mm bolt and thread it to 12 mm




Elliot Kites sigma 360 --- Rev Blast 2-4 --- HQ Scout 5.0 --- HQ Crossfire II 10.0 --- HQ hydra 350
2010 Liquid Force Havoc 10m -- Slingshot ranger 12m -- Peter Lynn Scorpion 16m -- EH Cabarete Freestyle

MBS Elements mountainboard
MBS atom cruiser (stake trucks and wheels)
Peter Lynn XR+ kite buggy (std wheels and wide treads)
KiteTrike
View user's profile View All Posts By User
awindofchange




Posts: 1924
Registered: 3-14-2006
Location: Salt Lake City, Utah
Member Is Offline

Mood: Awesome - totally awesome

[*] posted on 7-6-2016 at 01:06 PM


20mm is larger than 12mm so you would not be able to drill it out as it is already to big for 12mm. You may want to contact Van and see if he has any rails and axles laying around. His are not stainless though, just steel. I think I have a set of kite trike rails in storage somewhere, I don't have a rear axle though.




View user's profile Visit user's homepage View All Posts By User

  Go To Top

Hosted by: Mad Moose Hosting