Kamikuza - 14-1-2012 at 06:56 AM
Want to replace SZ1 & SZ2 on the 21... but can't see a way of doing it other than removing the entire bridle :o any suggestions? For DIY... I
could just send it to John again 
indigo_wolf - 14-1-2012 at 07:32 AM
Assume you are talking about this:
http://www.flysurfer.com/wp-content/uploads/lines/speed3/spe...
Are those segments sewn? Can you post pics?
ATB,
Sam
Kamikuza - 14-1-2012 at 05:52 PM
Yah... they just larks head onto the br3 lines - so it's a daisy-chain of larks head all the way down from the top... looking at that diagram, maybe
it won't be as bad as I imagined - I'll only have to undo the Z lines, nothing else.
But if there's a sneaky way to un-larks head a connection... that'd be good to know 
cos SZ1 joins both BR1 and BR2 which makes it tricky...