I would like to know if any one of you has a flexifoil buggy extra wide axle and could give me the measures to build one my self ?
I want to do this because my old flexifoil buggy was pretty hard to get and to get a extra wide axle will be a pain since there arent any
distribuitors near me and shipping cost + custums cost will be very high
so i hope u can help me out with the meassures and angles i must do since i know it extends to the sides and to the back as well.
thanks in advancekteguru - 16-9-2010 at 01:47 PM
I can post some numbers and angles tonite when I get back in. I know the axle itself is 135 cm. Will post the rest tonite.bigben91682 - 16-9-2010 at 02:06 PM
If you want to build 2, I'll happily pay you for the second! (seriously)
I've been trying to land this axle for a while but It's not easy here in the states.kteguru - 17-9-2010 at 07:51 AM
The back axle is 135 cm. Then measuring from the axle it's 25cm to a 30 deg. bend and the last part the side rails go into is 17cm. Hope that helps.mbi0 - 17-9-2010 at 10:44 AM
Quote:
bigben
If you want to build 2, I'll happily pay you for the second! (seriously)
I've been trying to land this axle for a while but It's not easy here in the states.
Im sure i can send it to United States Mate Or if u are any close to Mexicos border we can arrange a meeting soon since im at 2 hours trip from Laredo
or Mcallen Texas
Quote:
kteguru
The back axle is 135 cm. Then measuring from the axle it's 25cm to a 30 deg. bend and the last part the side rails go into is 17cm. Hope that helps.
It does help alot , thanks alot and ill be drawing this and uploading photo to be sure if i made it correctly mbi0 - 17-9-2010 at 12:37 PM
I Guess ill be doing it soon hopefully on sunday ill just like to know what in-oxidable tube measure should i use for back axle would a 6mm be enough
or should i do my idea of fiting a smaller diameter tube inside the outter tube and so on until i cant fit any new tubes and then weld em all on the
outside XD
